WorkForce RIPS: How do I change the ink packs?

Relates to

 

  • Replacing ink packs
  • WorkForce Pro:
    • WF-R5190
    • WF-R5690
    • WF-R8590

 

If an ink pack is low or expended, a message appears on your product and computer screen. Note which ink packs need to be replaced.

Warning:

Make sure you have your replacement ink packs handy before you begin. You must install new ink packs immediately after removing the old ones.

 

  1. Open the ink case.
    Note:

    The illustrations in this section show the black ink pack, but the procedure is the same for the colour ink packs on the other side of the product.

  2. Press the handle on the ink pack you are replacing.
  3. Lift up the ink pack and remove it from the ink case.
  4. Unpack the new ink pack
  5. Remove any protective materials, and do not touch the green chip on the handle area.
  6. Shake the ink pack horizontally 20 times as shown.
    Note:

    Do not remove any labels or seals, or the ink will leak.

  7. Place the ink pack in the case. Make sure the bottom of the ink pack fits over the base as shown.
  8. Place the ink pack handle on the holder as shown.
  9. Press in the handle until it clicks into place.
  10. Select Check on the LCD screen to make sure the ink packs are installed correctly.
  11. When you are finished, close the ink case.